No hay artículos en el carro
No hay artículos en el carroEl modelo en venta, es el modelo sin las reducciones
Alfredo Flores
Reseñado en México el 31 de agosto de 2022
Este es un producto muy bien hecho y de buena calidad, funciona perfectamente para hacer practica de tiros y además volver a levantar el objetivo con el simple hecho de jalar una cuerda. A recibido múltiples disparos de rifle 5.5 y no se deforma. Excelente compra.
Franck
Reseñado en Canadá el 6 de enero de 2020
Cool ecureuil bien fait solide
Mr. B. J. Montgomery
Reseñado en el Reino Unido el 5 de mayo de 2015
Good plinking target, wing nut exploded off the back so I put on nylock nut, apart from that is fine.
Greg
Reseñado en Canadá el 7 de agosto de 2014
Well made and functions perfectly. It's meant to be shot with a low to mid range power airgun though, highest power would be something like a .177 cal gun rated at 1000 fps or a .22 cal rated at 800 fps. My .22 cal RWS 350 Magnum started bending the Squirrel silhouette after a dozen shots as well as putting dents in it that bulge out the back side at a distance of 20 yards. My Gamo Hunter 220 in .177 cal does no serious damage to it at 20 yards but might at closer ranges. I have a Crosman 1322 modded to go 495 fps, and it has enough impact power to knock it down at 20 yards with a hit on the yellow bullseye. This is a fun target.
Dan F., WI
Reseñado en Estados Unidos el 6 de junio de 2013
I've had this for a couple or three weeks, and it's nothing but a total blast! Kill-zone-reducers? Some may think of them more as "ego-reducers". When you get down to that 1/4" opening, you had better be a REALLY good shooter. It's great, though, that you can choose your own challenge level & get better.First I was surprised at the weight of the target as it is made of sturdy 1/8" steel. Assembly was a snap and took only a few minutes to complete. The reset pull-cord is a braided nylon cord that will stand the test of time, but is also easily replaced when the time comes. The pull-cord comes wrapped around a metal, hollow "bow tie" for wrapping and storage (nice touch).To use the target without it falling over, you will need to use the included 4 metal stakes; all well and good if you are setting the target on soft ground, but an issue on hard surfaces or rocky ground. To make it easier to use on virtually any terrain, I simply took a 12" x 12" piece of plywood, screwed on some edging, and drilled holes to accommodate four small bolts. I attach the target to the board using the bolts and wing nuts. This setup also manages to catch the pellets that drop for collection and safe disposal (hence the board edging). As I use this target exclusively with lead pellets, I can keep my grounds relatively free of spend lead rounds.For paint touch-ups (with high gloss Rustoleum or the like), the contraption is easy to disassemble, paint and reassemble. A bit of oil on the springs and hinges, and you're set. Fun to use, and great feedback for good marksmanship. As your skills improve (or the accuracy of your airgun), you can make it more challenging 1/4 of an inch at a time.Note: Though I've used this well with both my and my , is doesn't work well with my less powerful .Shoot well and, as always, shoot safe.
Productos recomendados
