No hay artículos en el carro
No hay artículos en el carroDescripción del producto
M. Green
Reseñado en el Reino Unido el 9 de febrero de 2025
The supplied bolts didn’t not fit my 2022 Ninja1000sx. Had to find my own. Apart from that it’s fine and holds my RAM mount.
Jay Wilde
Reseñado en Estados Unidos el 30 de diciembre de 2024
The short screws too small, but the long ones a millimeter too long for the HD Road Glide handlebars. Got it right enough after playing with the bottom and top and lossening and tightening the top and bottom. Still not plush, but fine. Did work fine with my RAM arm once on.
T.E.
Reseñado en Estados Unidos el 2 de diciembre de 2024
This is an excellent clutch/brake perch mount kit that can save you space on your bar, if it will fit your bike. First you need to check the spacing between the bolts that hold your clutch/brake perch to the bar. It needs to be between 21 and 40mm center to center. The threaded end of the bolt is 22mm long once it is assembled to the ball mount with the washer and spacer. You need to be able to screw the bolt in at least 22mm, or have threads that are cut all the way through and open on the other side, which isn't common on newer bikes. If you don't have enough thread depth, you can cut these bolts down or buy shorter ones. It comes with six bolts in different lengths and thread pitches.
Wired Fuzzy
Reseñado en Estados Unidos el 29 de octubre de 2024
This is a lightweight but solid, durable mount that mounts to the handlebar by being attached to a lever clamp that replaces the that currently holds your clutch lever or brake master cylinder on the handlebars. This makes it easy to install, two bolts only, and the ram B (1") ball joints make it able to adjust to literally any angle you could possibly need. The design is great, and allows this to be used on handlebars that have no room for a standard handlebar clamp. This is a heavy duty well made mount that fit my master cylinder clamp perfectly, and the mount works very well, stays where it is put, and solidly holds my camera in place, exactly where I need it. I think this is an excellent unit for a good price and I can highly recommend it.
Craig
Reseñado en Estados Unidos el 9 de septiembre de 2024
Well-made easy to install comes with hardware needed to mount the only thing you may need is it socket set to remove the bolts on your existing lever. Once installed very sturdy, conveniently locates your phone. One thing to keep in mind if you have a sport bike with bearings that run close to your hand controls the chances of this working will be slim ones mounted it limits how far you were able to turn your handlebars if you’re on a cruiser bike or a naked bike with no fairings close by this would work great for those motorcycles I would just double check if you do have fairings when turning your handlebars Fully check your clearance from the lever to the faring. Otherwise, it is a quality piece,, very sturdy and solid The ball itself is like a tacky rubber seems to prevent the cell phone from vibrating downward
Productos recomendados