Carro de la compra

No hay artículos en el carro

No hay artículos en el carro

Laser 7644 Multi V-Belt Pulley Alignment Tool

Envío gratis en pedidos superiores a 25.99€

113.84€

51 .99 51.99€

En stock
  • Designed to check the alignment of Multi-V pulleys prior to fitting a new belt.
  • Manually adjustable silver steel alignment rod. Length: 250mm.
  • Main segment equipped with attachment magnets.
  • Target segment design to be held by hand where required.
  • Helps in the diagnosis of misaligned pulleys, failed idler pulleys, water pump, A/C pump and alternator bearings. Made in Sheffield. EU Registered Design.


Multi V-Drive Belts are almost universally used on auxiliary drive systems on modern motor vehicles. To ensure maximum belt life and avoid premature wear or belt derailment it is important to ensure that all the pulleys are correctly aligned.


AledoDMC
Reseñado en Estados Unidos el 25 de enero de 2024
A small (somewhat) weak magnet hold the butt end of the Aligning rod. It will hold it fine when Hanging or pointed Up/Down (vertically) only. It will not hold/support the Rod horizontally. It's useless
Tsquared
Reseñado en Estados Unidos el 3 de agosto de 2023
Good concept. Great animation on YouTube. Actual in field use not so great. The magnets that hold the large end with the steel rod are too weak. I could not use it hands free which is a big disappointment. If my engine were out of the compartment then using two hands would be no big deal. The price is way too high for the tool to begin with and doubly so since it doesn’t work.
John A. Bishop
Reseñado en Estados Unidos el 6 de julio de 2023
It worked. I used it for it's intended use.
Mike's RC World
Reseñado en Estados Unidos el 9 de junio de 2023
I bought this to assist myself in getting the March pulleys lined for my 509ci BBC. I could see by eye the crank pulley was going to need to be spaced out to match the power steering/alternator. I didn’t want to buy the expensive laser tool, because it’s expensive and figured this tool could get the job done. The idea of the tool is GREAT…however the tolerances of holed drilled in the plastic part which sits on the pulley and holds the metal pointer alignment part of the tool are off significantly… it has enough wiggle room to be nearly an entire rib off. Anyone who has fought belt alignment issues knows that if you are off a rib like that you’re gonna have massive issues with shredding or throwing the belt. The tool should have a much much tighter fit so that the pointer doesn’t have any wiggle and gives a more accurate alignment reading. Ultimately I had to purchase the laser tool. Disappointing to say the least.
Tor O.
Reseñado en el Reino Unido el 14 de marzo de 2020
Has a problem with bigger pulleys as kit gets wobbely, thought perfect for smaller pulleys.
Productos recomendados

40.58€

17 .99 17.99€

4.3
Elegir

99.92€

42 .99 42.99€

4.6
Elegir

39.95€

19 .99 19.99€

4.8
Elegir