No hay artículos en el carro
No hay artículos en el carro LCD12864 Display Controller Adapter Board with Adapter and Cable for 3D Printer RAMPS 1.4 Reprap Mendel Prusa for Arduino
The intelligent controller includes an SD card reader, rotary encoders and a 20-character×4 line LCD display.
You can easily connect it to your RAMPS 1.4 board using "smart adapter" included.This panel connect your RAMPS 1.4, you do not need your computer, your SD card intelligent controller power supply.
All further operations, such as calibration, the axis movement can be done only with a rotary encoder intelligent controller. 3D design print without a computer, just use the G code design stored on the SD card.
Package Included:
1 x 12864 LCD with Control Panel for 3D Printer
1 x Connector
2 x Cable
Enrico Maria Oggioni
Reseñado en Italia el 19 de febrero de 2023
Nessun Commento Particolare
K. Bell
Reseñado en Estados Unidos el 30 de diciembre de 2023
CURRENT REVIEW: 1/06/2024Quality control seems non-existent, this one the POT to adjust contrast DOES NOT WORK. It is also so bright that TEXT is washed out. HORRIBLE.Debating if I want to go through the hassle of packing it for return AGGRAVATING! After waiting for it to ship then getting a complete lemon.PREVIOUS REVIEW:Contrast not as high and sharp as previously purchased.WARNING!!(Accidentally placing a STEPPER DRIVER in upside down, will more than likely FRY EVERYTHING including this connected LCD).For this reason specifically, STEPPER DRIVERS should be designed with an alignment PEG/HOLE, making installing upside down impossible - this is a simple design change, not requiring fancy resistors or capacitators. FOR ALL MAIN BOARDS
Ronald P.
Reseñado en Estados Unidos el 20 de octubre de 2023
the display works nice, a good addition to my ANET A8 printer, the only problem I found is the the pins are wrong backward had to reverse the pin locater around, with needle nose pliers carful not to damage the pins, went to all four corners little by little until it came off then reversed it. other wise would be 5 stars
M. Marek
Reseñado en Estados Unidos el 7 de junio de 2022
I am alwys happy with HiLetGo delivery and product value.The original Smart Controller Board in my Tornado 3D print encoder failed.The Tornado has a MKS GenL V1.0 motherboard and at first the LCD would notlight up. Found that I did have to reverse the ribbon cables at the controller whichrequires sanding off the connector key. Once I did that everything fired right upand the printer is back online.Did not rate the Touch Screen category simply because this display is not touch screen
Niki Schering
Reseñado en Estados Unidos el 25 de enero de 2021
If you read some forums about the original clones of the Discount Smart controller the said you have to flip the sockets over on the board. This is not true with this unit.. It works as delivered.Running with Marlin 2.07 I added this line to prevent display creep.add before the getting started line in Config.h// Display creep timing fix for RepRap Discount Full Graphics display#define ST7920_DELAY_1 DELAY_NS(0)#define ST7920_DELAY_2 DELAY_NS(400)#define ST7920_DELAY_3 DELAY_NS(0)
Productos recomendados
