No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Package
1 llave de cigüeñal.
Tonto
Reseñado en el Reino Unido el 20 de agosto de 2024
As described.
Ebo Eppenga
Reseñado en Países Bajos el 22 de octubre de 2023
Werkt prima om de krukasbout van een Honda vast te zetten. Let op, is wel ietsje aan de kleine kant waardoor je wel even moet kijken of het goed vast zit. Maar doet zijn werk prima!
David A.
Reseñado en el Reino Unido el 28 de abril de 2021
Good fit in Honda Accord crank pulley, quality forged steel.1/2" drive ratchet lines up nicely with front lower suspension arm to brace it while having at the pulley bolt - N.B. pulley bolt will need *huge* anount of torque to remove, probably close to 400 lb-ft! Maybe more!
Danish Latif
Reseñado en el Reino Unido el 22 de agosto de 2020
The tool could fit better as it’s not as “snug” as you’d expect it to be. However it did its job perfectly as it held the pulley in place via a bar anchored to the ground, while I was able to loosen a stubborn bolt with a second car. Invaluable tool, helped me where an impact did nothing.
T. Mcilwain
Reseñado en el Reino Unido el 3 de septiembre de 2020
This absolutely does the job its a good fit well made and very reasonably priced, manual says loosen engine mountsto drop engine 50mm for access to bolt but didn't have to this goes in at an angle and if you fit the breaker barinto the back of the the 1/2" square hole ie engine side, the bar will wedge between wishbone and chassis then on the 19mm bolt I just used the ratchet with a cut off section of an old trolley jack handle to extend the handle position yourself lengthwise with the car and push ratchet handle with two feet (car is well secured on axle stand) Bob's your uncle
Productos recomendados